Most of the time, businesses will spend lots of money to purchase their lift trucks. It is important, therefore to take proper care of your machine to protect your investment into the long run. It is a good idea to know the procedures which are carried out in the care and maintenance of this piece of machinery.
Amongst the best ways to tell how good the engine is running is by starting the forklift up and listening carefully to see how it works. For example, if there are any knocks or misses, the machine is faulty and this must raise some issues. Moreover listen carefully for any squealing sounds that come from the belts because these noises would provide you with a wealth of information.
Some of the main components requiring attention during maintenance include the gauges, horn, safety warning devices, the overhead guard and the lights. Any burnt out light bulbs or faulty components should be replaced as soon as they are noticed. It is also vital to inspect the wiring.
The battery compartment terminals must be cleaned after the above parts have been inspected thoroughly. If the terminals are not clean, be sure to clean them well. Each and every cell of the battery must be inspected in order to make certain that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and then change the filters. The fuel filters, hydraulic filter and the transmission filter should be replaced on a regular basis. Prior to fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
When the oil change has been carried out and new filters have been fitted, visually inspect the drive axle from beneath the machinery. Be certain to grease the axle if there is any grease fitting. Check the belts on the engine for any frays or cracks. If you find any, fix the problem accordingly. Next, check each and every other component of the equipment like the wheels. If any kind of fault or problem is detected, be sure to address it immediately in order to make certain the equipment is working at its safest and optimum levels.